I have an RVS4000 running V220.127.116.11 firmware that gives me an "Invalid Character(s) Found" error message when I try to edit an existing ACL.
I'm trying to deploy 57 of these routers and would like to be able to use a pre-built config dropped onto each router.
I initially planned on editing the exported config with a find&replace for my local LAN addresses. Since that didn't work the next reasonable solution would be to edit the ACL list (much more tedious, but still better than hand-entering every ACL on all 57 devices).
Can you please tell me when this bug will be addressed? Alternatively, if there is an offline configuration editing tool I would be one happy camper to have it!
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...