I have a customer who recently bought a RVS4000 router (firmware 1.2.11). The customer is hooked up on a 50/50Mb fibre connection but the maximum bandwidth the customer can get out of the RVS4000 router is 18/18Mb. The 50/50Mb connection is working fine, the speed has been measured to be correct.
According to the Data Sheet the router should be able to support 1000Mb.
Here's the question - what should be done to get the router working on full speed?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...