I have set up our RVS4000 for a static IP with the information that Verizon gave me. I now wish to change the DNS servers to OpenDNS in order to take advantage of their filtering services. But on the WAN screen it only shows the dropdown to select connection type, which is set to Static IP. It does not show any of the static IP information so that I can change the DNS servers.
How do I edit the WAN Static IP information so that I can change our DNS servers?
Thanks in advance for any help you guys can offer!
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...