I'm trying to set up a site to site VPN for a client with 2 RVS4000 VPN routers. The main office router is in use with no issues. I'm attempting to login to the second identical unused router as "admin" with a password of "admin" which is not working. I performed a 10 second reset per the users guide but still can't login. Something else that seems strange is that the users guide states that the IP should be 192.168.1.1, but it is 192.168.1.2. I'm guessing that it may have been previously configured and that the router is not resetting properly or it could just be junk.
It sounds like the reset did not take. I would try holding in the reset for at least 30 seconds. If the reset was successful it should reset the LAN IP of the router to 192.168.1.1 and the password to admin. Try holding in for 30 seconds and see how this goes.
Hi Rick, what about if I need to reset the password but I need to keep the current configuration, this is very important, the guy that was handling it pass away and we need to access this router. any Idea how to do it?? thanks in advanced.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...