We have a client with several disperate sites, currently running either very old Snap Gear routers, or DD-WRT flashed linksys devices.
We have started moving them to RVS4000 hardware at their smaller sites.
I can't work out how to get the device to redirect port 80 + 443 traffic to the parent site via VPN.
They currently have (via the old devices) a connection to their local ISP via ADSL and a VPN connection to their parent site. The routers are configured to block some traffic, and send all web traffic to the parent site (for filtering, monitoring, logging etc).
How can we configure the RVS4000 to replicate that behaviour? (port blocking is fine using the P2P/IM pages) I can't work out how to just forward TCP/80 and TCP/443 out the VPN connection.
Just reading your post but not near a RVS4000 at this time. I know when we set up Small Business Routers for IPSec VPN, we specify a Local subnet and a remote subnet, per tunnel. SO if each site has a unique local subnet (192.168.10.0/24, 192.168.20.0/24, ...etc.) then when you build the tunnel between the two sites, you will specify these networks.
So any client in site A who wants to query the Webserver or Print server, whatever, of site B uses that other sites Private NAT subnet address, and the tunnel routes it there.
I once set up a branch site that had internet access, but it was desired behavior to route ALL client traffic originating from the branch, via the main campus before hitting the internet (for logging as you said).
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...