I am trying to configure the router to use Dameware Ports 6129 & 6130 on multiple machines. Is there a way to add multiple computer IP addresses in the single port forwarding or port range forwarding sections? Any assistance will be greated appreciated.
Other than doing a different external port to the same internal ports, and performing port forwarding that way, the only option you have is to do a trigger port and that way anything needing to access your network with those ports are in. It don't let the firewall block them if they are on a trigger. I would try that and see how it goes.
I'm not sure exactly what I did to make it work. I did make an IP Based ACL policy to allow the Dameware ports. Also, an Internet Access Policty for the computers that are accessed via Dameware. We did try the port range triggering before this, but still had the issue on the PC that was outside our network. Thank you very much for your reply though, I appreciate it.
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...