I have RVS4000 configured to listen to multiple IP on WAN side.For this to work my config is like this:
WAN holds the "routing" segment 188.8.131.52/31 of my public IP subnet
WAN IP static: 184.108.40.206
WAN gateway: 220.127.116.11
Lan holds the first IP of my public IP subnet 18.104.22.168/28
LAN IP static: 22.214.171.124
LAN subnet: 255.255.255.240
Everything else under LAN settings is empty.
Here I have:
Operation Mode: ROUTER
RIP Send Packet Version: RIPv2
RIP Rcvd Packet Version: RIPv2
So, practically I have LAN side configured with public IP and no NAT between WAN and LAN side.
PROBLEM here is "single Port Forwarding", for example:
1.) I have 2 mail servers behing RVS4000, so I want to open port 25 on 2 IP addresses...but I can't! Cisco says, that 2 rules of port forwarding are the same and does not accept one of them. Any idea?
2.) Some single port forwarding rules simply do not work?! Straight forwarding a port xx to xx works, but from port xx to YY does not...or it does, until I add another rule. Meaning, that if at some moment all port forwardings work, they may NOT work after I add another rule.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...