I have recently purchased a RVS4000 VPN Router and I have a slight problem I wish an expert to help me with.
At home I have a 100Mbps internet connection which gets a result of around 80-98Mbps on the speedtest.net . However, when I connect the RVS4000 to my network I can only achieve 20Mbps. I am using Cat 6 cabling for everything with Gigabit ports. The QoS / bandwidth settings are disabled.
IPS is resource (CPU) intensive. We used it for years with a WRVS4400N v2 and now with an SA540. Even with the more expensive SA540 we our WAN throughput is limited to ~24Mbps. We pay for 30Mbps down and 5 Mbps up so we aren't losing much.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...