I have a basic home system that is using the SA 520 because we were recommended to use this becasue of the amount of devices. The same problem still persists with the WIFI being very problematic. I am trying to enable port forwarding to 192.168.1.4 through the router which is at 192.168.1.1 local and has a dynamic outside IP address. I have tried using IPv4 rules with HTTP and HTTPS but I still can not get it to work. Trying to give the WIFI tech access to the WAP. Basic instructions or something that I may have missed would be great. When trying to access I am using the outside IP and port. Such as HTTPS://55.555.555.555:8060
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...