I am experiencing difficulties in setting up a VPN between a SA520 router in a home office and a UC540 router in the central office.
Since CCA can only configure the basic settings of the SA520, I used the SA520s web interface for VPN configuration using the IPSec wizard, but the VPN connection keeps failing with an SA provisioning error.
Are there any configuration examples or guides on hot to configure an SA520 to use the IPSec VPN on a UC500-type-router ?
And are there any instructions on how to configure the routing on a SA520 for the phone network (10.1.1), with best practice VLAN and QoS settings ?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...