Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP - Not so "Simple"

Hello,

I am somewhat new to newtworking and I was tasked with getting Solarwinds to communicate with all of our network equipment.  I have been able to get everything into Solarwinds and recognized but our ASA is not returning SNMP information.  I have been running a tool called getsnmp.exe and I can get a response from my workstation after adding my ip address into the asa host access list.  If I then add the SolarWinds server to the Host access list, snmp still times out.  If I try from another workstation and add it to the list, it also times out.  If I change the ip address to match my workstation address, snmp works.  I am utterly confused as to why it is only working with my IP address of my workstation.  Everything is on the same subnet.  Any help please?

1 REPLY
New Member

The firewall can be managed

The firewall can be managed via up sown pretty easily as a node.

as long as you enable

SNMP Host and the interface Poll Community

SNMP Host and the interface Poll Version

Once you get that going you will probabaly need to dig a little for the IKE OID's to check tunnel states.

or for number of connections etc...  It realy depends on your monitoring strategy.

 

Hope this helps.

 

Carl

146
Views
0
Helpful
1
Replies