I have been attempting to setup IPS from within CCA for awhile now with no luck. I own a contract and have downloaded what I thought were the correct files from within CCA. It seems like it is loading, then just goes blank. Has anyone had any luck configuring this feature?
I am trying to set up the IPS function of the SR520. From within CCA, there is a link for IPS, then a window that asks for a public key and a link to download it. Then, a link for the sdm ips signature. After logging into the Cisco Support Site, I am able to see signature updates, but no initial file. If I download the current update and try to install, the update fails and the screen returns to original state of the window. Did the update take place? It does not appear on the show run command.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...