I got the same issue, i have a vpn site to site between sr520 and rv04,and would like to allow complete trafic between these two offices, or almost complete trafic, because behing sr520 a got a IPPBX directly connected, and on the other site RV042 I got several remote IP extentions.
I´ve tryed with an extended access-list between my lan on sr520 and remotes rv042 lan, with no results
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...