I am working on a UC520 solution that involves 6 remote locations that will have two phones in each location. The proposed project includes 6 SR520 routers. When trying to hammer out my configuration in a lab, I have found the Easy VPN does not provide for access from the Hub site back to the private network of the remote. My customer will need that capability to manage the PC's in those remote offices.
I am in need of some instructions on how to configure a full two way Site to Site VPN. Any help in finding documentation would be greatly appreciated.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...