I'm attempting to configure my SR520 (not UC520) via the Cisco Config Assistant. On the VPN screen it requires that I download the SSL VPN client to be downloaded by the client once it makes the connection attempt (REMOTE VPN). Does anyone know where I can get this client? Cisco says I need a smartnet contract to download it....I just purchased the device yesterday.
Well Here is the long and the short. Yes, you need to have support for the device before you can download the SSL Client. But The SR520 comes with 1 Yr of support via phone and 30 days of software fixes. Now after you get the support contract from the Distro, like CDW, you need to add it to your CCO account. Then you can download the client from this link.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...