ive got an SR520 that ive been playing with to swap out our netgear prosafe router.
im also using cca 3.2
ive logged into the router and configured the internet connection on the cca and applied but am not getting a connection. i think i know what the problem is but i dont know the comands to fix it.
basically the password for the adsl isn't being sent to the router correctly and i think all i need to do is navigate to that area via CLI and set the password in there rather than using the CCA, has anyone done this before and would it be possible to give me a walk through of what cmds i need to put in to change the password for the ppp auth via the CLI
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...