Is it possible to configure wireless guest access using the built in AP of an SR520W-FE-K9 using CCA. If it is not possible to use CCA, can the CLI be used without breaking CCA functionality such as VPN configuration. Customer requires a firewall between the wireless guest VLAN and the corporate network. Built in AP will be used only for Guest VLAN (SSID) to the internet (WAN Port). No traffic can pass between corporate and guest VLAN.
I searched and found discussion “SR520 Guest Wireless setup” and tried to add an ACL but you will then get an error when building a secure VPN connection using the CCA. “Unsupported Access List”
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...