I have obtained some of the 527W-U devices and I've noticed a strange change to IKE policies and IPSEC policies on this version of the product.
On the previous model SRP routers, IKE policies could be used by multiple IPSEC policies, but on this version, I cannot use the same IKE policy for more than one IPSEC policy. I am running the 1.2.4 firmware.
This has rendered the device useless to me, as I need to connect multiple non-contiguous subnets behind a single ASA over IPSEC.
Does anyone have a workaround for this?
I have flashed the 520-U with the 1.1.26 firmware, which is running, but I would assume that this is an unsupported workaround by Cisco.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...