Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SRP 546w adsl+ Annex B adsl configuration problem.

Dear All,

           I have the above router trying to use to access BT ADSL 2+ circuit. It came with BT home hub which works fine. I need to use this circuit for our Guest WiFi therefore needed to swap the BT Homehub for cisco SRP 546w ADSL+ Annex B.  After being through all the configurations when I connect the line to the DSL port the light aren't able to come up.  When I chceked on the status it showing as DSL Modulation  Not Trained .

Any ideas? 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

SRP 546w adsl+ Annex B adsl configuration problem.

Hi Jonathan,

Unfortunately, you have the wrong product for connection to a BT service.  The SRP546 is used for connection to ADSL services delivered over digital ISDN telephone lines.

For the UK, you will need the SRP547, which works with ADSL services delivered over analogue telephone lines.

Regards,

Andy

2 REPLIES
Cisco Employee

SRP 546w adsl+ Annex B adsl configuration problem.

Hi Jonathan,

Unfortunately, you have the wrong product for connection to a BT service.  The SRP546 is used for connection to ADSL services delivered over digital ISDN telephone lines.

For the UK, you will need the SRP547, which works with ADSL services delivered over analogue telephone lines.

Regards,

Andy

New Member

SRP 546w adsl+ Annex B adsl configuration problem.

Thanks Andrew, there was a mix up in the order.

599
Views
0
Helpful
2
Replies