Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRP500 en voip routing fails at transfer

hi all,

we have an Cisco SRP526W with some issues regarding the transfer of calls.

We have a couple of SIP phones (Gigaset N300 IP) (not connected to the fxo ports) and when a call is beeing transfered to another sip account its coming back instead of being transfered. This occurs once in every 3 attempts.

allready tried:

- disable SIP-alg

- moved the phones into a seperate v-lan

- contacted the voip-provider, who says: "We sell about 300 of these phones and never heard of this", we have tried differen sip ports etc, but no result.

3 REPLIES

SRP500 en voip routing fails at transfer

What is the firmware version installed on your SRP? Try the last 1.01.24.

Previously versions have some bugs about IP Phone connected to the SRP LAN.

See release notes at this link:

http://www.cisco.com/en/US/products/ps10500/prod_release_notes_list.html

Disable SIP alg is OK but set the righr port forwarding rule for NAT traversal. SIP port but also RTP ports.

If the problem is not fixed get a trace of the call (SIP signalling) and post the output.

Regards.

New Member

SRP500 en voip routing fails at transfer

Hi Bart,

We recently got a few 300A IP's and are having transfer related problems too.

Only for us the transfer of external calls always succeed while internal calls cause the N300A to crash and reboot.

I'm fairly sure the problem originates in our Cisco CM 8.5 though.

Transfers fail on other 3rd party SIP devices as well, but without the crash and reboot.

New Member

SRP500 en voip routing fails at transfer

The funny thing is dat the N500IP Pro was having the same problems behind this modem.

I have a hard time believing that the N300 is causing the problem. In my humble opinion it's a routing problem.

761
Views
0
Helpful
3
Replies
CreatePlease login to create content