One of our customers has project in which he is planning to instal SRP527W with dynamic IP address provided by ISP.
They wan't to use DDNS to communicate with the devices in the local network, this part is easy as we know that we need only port forwarding and set up DDNS.
The second requirement is to access via DDNS name servers in LAN network from computers that are in the LAN. So that we can use the same DDNS name to access servers no matter if we are outside the LAN or inside the LAN. Is it possible with SRP527W, if not maybe some SR500 series?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...