I've been having the lockup issue with the SRP527W (infact this has been an extremely embarassing situation after spending 4 x what I could have on a Netgear type unit, to do the same task). I've not yet managed to get hold of the new firmware (MR3) as I've not received the email with a link. Can anyone here provide it for me instead?
On another note, I'm not sure if this has been covered in other posts, but, when my unti stops working (Wireless still alive, no internet) - the CPU hits and stays at 100% and only a reboot fixes it.
I've followed the instructions at https://supportforums.cisco.com/docs/DOC-13853 and havent yet received a reply email. First email was Feb 10th and the 2nd today. My profile has the correct email address, as I was at least notified about the reply to my Forum post, via email.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...