I have a Small Business Pro SRP527W (Firmware 1.01.9) which I am connecting to an ADSL service. I can get this working using the Quick Setup links, reserving IP addresses for my servers and configuring port forwading but there does not appear to be a link for changing the default password. Every time I log in I am greeted with the Platform Setup Wizard. If I run this wizard the router stops working, in that I can no longer access my websites, FTP site or remote desktop (they are still shown in the port forward list and still shown as enabled).
Anybody got any ideas? Either how to change the default password without using the wizard or how to disable the wizard.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...