Hi There,
I am trying to setup site-to site VPN with SRP527W firmwar (1.02)
Example:
Site A - IP Address - 192.168.1.x /24
Site B - IP Address - 192.168.2.v .24
VPN Status Showing connected. Routing table showing ipsec0 interface for remote location traffic. I can ping the remote site gateway(192.168.1.254 from 192.168.2.x range but can't ping or connect to PC connected in 192.168.1.x). I have downgraded firmware to 1.01.27 and then to 1.01.23 but no difference.
As far as i am aware, i don't need to configure any NAT or static route when VPN tunnel is up but is it something that i am doing worng?? Please help...!!