Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

SRP527W Site To Site VPN

Hi There,

I am trying to setup site-to site VPN with SRP527W firmwar (1.02)

Example:

Site A - IP Address - 192.168.1.x /24

Site B - IP Address - 192.168.2.v .24

VPN Status Showing connected. Routing table showing ipsec0 interface for remote location traffic. I can ping the remote site gateway(192.168.1.254 from 192.168.2.x range but can't ping or connect to PC connected in 192.168.1.x). I have downgraded firmware to 1.01.27 and then to 1.01.23 but no difference.

As far as i am aware, i don't need to configure any NAT or static route when VPN tunnel is up but is it something that i am doing worng?? Please help...!!

Everyone's tags (3)
564
Views
0
Helpful
0
Replies
CreatePlease to create content