Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SRP527w Static Routes

Hi All,

We have 2 sites with 2 internet connections at each site. All are SRP527w routers. 1 is for internet and 1 is for a site to site VPN as shown below:

VPN layout.JPG

192.168.2.254 Public IP 120.10.25.35

192.168.3.254 Public IP 120.10.25.36

(All IP's are examples not our IPs)

Currently we are using Static Routes on the PC's so they can access each server no matter what site they are at. I have looked at using the Static Routes section on the SRP's but cannot get it to work. Was wondering if someone has done this before and if s what i might be doing wrong.

Cheers,

Ross

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions

SRP527w Static Routes

On your PCs/servers you must configure the default gateway only, in your case the SRP used to connect in Internet.

Server 1 Default Gateway: 192.168.2.1

On this SRP you must add a static route like this:

ip route 192.168.3.0 255.255.255.0 192.168.2.254

You must replicate the config for server/site 2 and adjust ip addresses.

Use ping and tracert for test.

Regards.

2 REPLIES

SRP527w Static Routes

On your PCs/servers you must configure the default gateway only, in your case the SRP used to connect in Internet.

Server 1 Default Gateway: 192.168.2.1

On this SRP you must add a static route like this:

ip route 192.168.3.0 255.255.255.0 192.168.2.254

You must replicate the config for server/site 2 and adjust ip addresses.

Use ping and tracert for test.

Regards.

New Member

SRP527w Static Routes

Thanks Daniele. Works perfectly now.

1265
Views
0
Helpful
2
Replies
CreatePlease login to create content