I have an SRP541W, and when I try to upgrade the firmware from 1.2.4 to 1.2.6 I get an error:
Upgrade has failed.
SRP541W is restarting...You will be returned to the Login page in few minutes.
After the reboot I check the logs, but there are no entries. Any help would be appreciated. I really hate this router. Nothing but problems from day-one. I don't think I'll ever buy another Cisco product again. Arrrrr!
Sounds like your new version of 1.2.6 may have been corrupted (the SRP verifies the new image before attempting to boot from it - if that verification fails, it rolls back to the previous version).
Please download the image again and try again. You can use an MD5 checksum application to verify the image before installing if you wish. The checksum is published on the same page as the firmware download.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...