Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

static route over vpn with WAG54GP2

I setup an ipsec vpn between two WAG54GP2 and everything works properly, since the two networks communicate properly with each other without any additional configuration.
One of the two router (172.30.209.130) routes traffic to a MPLS network (gateway 172.30.209.129) by the following static routes:

 

Destination LAN IPSubnet MaskGatewayHop countInterface
62.94.58.1255.255.255.2550.0.0.01WAN (Internet)
192.168.11.30255.255.255.255172.30.209.1291LAN & Wireless
172.30.140.130255.255.255.255172.30.209.1291LAN & Wireless
172.30.209.128255.255.255.1920.0.0.01LAN & Wireless
192.168.9.0255.255.255.0172.30.209.1291LAN & Wireless
0.0.0.00.0.0.062.94.58.11WAN (Internet)

 

From the remote router (192.170.1.1) I can not access the MPLS network as trying to configure the same route I have in response "The values you entered are invalid. Please try again."
I get the same error trying to insert as a gateway to the remote router 172.30.209.130.

 

How do I configure the router for remote access to the MPLS network?
 
Everyone's tags (4)
1 REPLY
Cisco Employee

Re: static route over vpn with WAG54GP2

Dear Sir;

Unfortunately, we don't provide support for this product. This product is still a Linksys product, please contact Linksys technical support for further information (www.linksys.com)

Regards;
Alberto

2169
Views
0
Helpful
1
Replies
CreatePlease login to create content