Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Teething issues with RV110W

Just thrown out the old Vigor 2830 router as the firewall/port-forwarding functionality seemed to be fundamentally broken.

Now I've got an RV110W and it's looking encouraging, but...

I want to set up a firewall rule to give my VPN user full access to our LAN.

I can create an access rule in the firewall section, there's something very odd indeed about the "Destination IP" select control. It says "Single Address" and I can't change it.

BUT, if I cut and paste that screen here, look what it shows! Extraordinary!!!

 

Connection Type:
Action:
Schedule:  
Services:  
Source IP:
Start:   (Hint: 192.168.1.100 or fec0::64)
Finish:   (Hint: 192.168.1.200 or fec0::c8)
Destination IP
Start:
Finish:
Log:
QoS Priority:
Rule Status: Enable
Everyone's tags (1)
1 REPLY
New Member

Mmm, that looked different in

Mmm, that looked different in the editor than it does now.

Essentially, the cut & paste shows "destinationIP=Any" (which is how it seems to behave)

Maybe there's a firmware update to be had....

1
Views
0
Helpful
1
Replies