Tunel connected but cannot ping unless virtual IP in WAN access rules
Hi, I am trying to connect to VPN created on RV042.
Tunel is created ok, but I cannot connect to any devices on target network unless I add virtual IP of my network adapter (say 192.168.10.10) to firewall rules list as comming from WAN1. But why should I add need to do that? I am connecting from public ip (say 22.214.171.124) so this address should be enough if I want to limit access to this public IP only right?
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...
Article ID:5708 Configure the LAN and DHCP Settings on the RV34x Series
Router Objective A Local Area Network (LAN) is a network limited to an
area such as a home or small business that is used to interconnect
devices. LAN settings can be configured to li...
Article ID:541 Firmware Upgrade on RV016, RV042, RV042G, and RV082 VPN
Routers Objective To upgrade the firmware, a specific file must be
downloaded from the Internet and uploaded to the device. Firmware
upgrades can fix software bugs, improve features, a...