hi .. I have a Cisco RV042 Router an have configured the VPN Connection successfully ... I am connected via PPTP from outside my network, and would like to switch to this network via the WOL pcs one (and also - via shutdown cmd). The switch is not really a problem ....
The WOL Magic Packet is created using a. NET application. My problem now is that the UDB broadcast packets that are needed for WOL, the router will not pass. Direct IP-addressed packages come without problems, through the VPN tunnel.
Now I wanted to ask if there is a possibility with the Cisco RV042 router broadcast packets to pass through, so in the firewall or any other different settings, or if I pack the Magic Packet is somehow different, so it comes as a broadcast packet on the computers, but addressed as a package is sent away ....
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...