Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using WRVS4400N for DHCP relay on remote IPSec VPN LAN

Hi,

I have a WRVS4400N. I want to know if it is possible to configure the WRVS4400N DHCP relay to look for a DHCP server on the remote LAN. The local LAN is 192.168.2.0/24 and the remote LAN is 192.168.1.0/24. I entered 192.168.1.100 in the DHCP relay server field but my local PC does not get an IP address. So, I would like the local PC to get a DHCP 192.168.2.x IP address from the remote DHCP server (LAN) across the IPSec VPN tunnel. Is this possible?

The IPSec tunnel is functioning. I can ping the remote 192.168.1.100 DHCP server, if make the local PC a 192.168.2.x static IP address. I have setup the DHCP server with a 192.168.2.x/24 IP range.

The remote VPN router is a Netgear FVS114.

Thanks,

Nic

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Using WRVS4400N for DHCP relay on remote IPSec VPN LAN

The wrvs4400n will not allow you to do the dhcp relay through the vpn tunnel.  You might have to get a enterprise solution for that or a point to point connection to have both of the networks on the same lan setup.

1 REPLY
Silver

Re: Using WRVS4400N for DHCP relay on remote IPSec VPN LAN

The wrvs4400n will not allow you to do the dhcp relay through the vpn tunnel.  You might have to get a enterprise solution for that or a point to point connection to have both of the networks on the same lan setup.

1745
Views
0
Helpful
1
Replies
CreatePlease to create content