I have recently installed a WRV200 and updated to to firmware 1.0.39ETSI Ethernet and Wireless connectiviety from the local LAN to the internet is working fine but I'm having difficulty in getting any remote VPN users to be able login using the Quick VPN software.
I have generated the VPN certificates, exported it for client and copied this client certificate to the remote PC using the quick VPN software. When trying to connect with the Quick VPN software it begins to connect and I see dialog boxes saying 'Connecting...' then 'Activating Policy...' then 'Verifiying Network....
After about 60 seconds I then get a dialog box stating that the remote gateway is not responding and do I wish to continue to wait.
This problem is consistent accross 4 PCs all running WinXP SP3.
My Quick VPN version is v188.8.131.52
Anything else I need to be doing or that I may be missing?
Anything else you may need to know please ask, Thanks in advanced, Gavin
Can you try connecting with the newest QVPN client version 184.108.40.206? You can download that from the Cisco website. Also, I assume the network that you're connecting from is a different subnet than the WRV200?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...