My current configuration is a AM200 configured in gateway operation mode which is responsible for establishing my internet connection via PPPOE (IP-192.168.253.1). This works no problem if I connect a PC to this setup. Now I add my WRV200 to the configuration, by connection the WRV200’s WAN port to the Ethernet Port in the AM200. I configure the WAN interface on the WRV200 as a fixed IP with the address of 192.168.253.2. The LAN on the WRV200 is then configured as 192.168.254.1. All of this works if the WRV200 runs in gateway mode. Since this creates a double NAT I wanted to change the WRV200 to run in router mode. Once I make this change (and added a static route on the AM200 for the 192.168.254.0 network) all the networks can see each other and I can ping the internet no problem, except that nothing else works to the internet, browsing SMTP etc. Change it back to gateway and everything works.
Surely this must be possible on the WRV200, I’m a certified Cisco engineer so I know how IP worksJ. Please advise on how this configuration can be achieved.
Basically I want the am200 to run as a gateway, the wrv200 as a router and vpn server. The reason why I want connectivity to the am200 is so that I can manage it via SNMP and the web interface.
Kind regards, Emil
I've taken your question to so some specialists, who will get back to you as soon as possible.
Thanks for your patience,
Cisco Moderation Team
We have looked at you configuration and we are unable to find any issues with the WRV200 router. We would recommend to call our customer service center to get more help, they may ask you to get some configuration on your routers and some capture files.
Please call our support center at
I have the same issue.
The problem has appeared after firmware upgrade to version 1.0.39. Now my router works fine in gateway mode, but I can't establish any external connection in router mode.
PC -> WRV200 -> Linux router -> Internet
I can ping Internet in router mode, I can connect to Linux router, but neither UDP nor TCP transit packets destined to external networks achieve Linux router. However, networks which are set at "Advanced Routing - Static Routing" are fully accessible. It seems that the "Default Route" exists only for icmp packets in router mode. :-)
If you can ping to the internet even with the WRV200 as Router Mode, we don't see any issue with WRV200, this it might be related to the other router
Target_ii summary is 100% correct, my conclusion was also the same, icmp no problem, anything else no go!
Kind regards, Emil
Hi, any news?
I have same issue. ICMP packet are routed well but TCP or UDP packets are blocked when operating in route mode. Firmware version: 1.0.39