The web ui on my WRV200s (I have about 100 pieces...) intermittently becomes inaccessible. It usually dies within a day or two, but sometimes it will stay up for a couple weeks. The router still responds to pings while in this state and everything else seems to work (including VPN IPSec). When the web ui dies, I have to power cycle the device to get it going again.
Is there a work around to regain access to the web UI remotely? I do not have physical access to the device at all times so power cycling is not a practical solution for me.
Thanks in advance for any information on this issue.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
** Update **These and a number of other issues have been addressed in
SRP520 MR3. Please see https://supportforums.cisco.com/docs/DOC-13853
for details on how to access this code.There have been a number of
reports of the SRP500 becoming unresponsive afte...
STANDARDSOURCECOMMENTSEthernet RJ-45 connector pin number12345678IEEE
802.3afusing data pairsRXDC+RXDC+TXDC-sparespareTXDC-sparespareIndustry
Standard for Embedded POE(used by Cisco Catalyst Switches)IEEE
802.3afusing spare pairs RXRXTXDC+DC+TXDC-DC-Indus...