DID ANYONE KNOW THAT ON OUR CISCO WEB CITE WE HAVE 1.1.16 POSTED AS THE LASTED FIRMWARE FOR WRV210, BUT CUSTOMERS HAS AN LATER VERSION 1.1.17. DOES ANYONE KNOW WHEN WILL THE NEW FIRMWARE WILL BE POSTED? SHOULD WE ESCALATE THE CASE?
So, it's OK to release new non-verified firmware to retailers/unknown-customers, but existing customers have to wait for GPL verification? Seems inconsistent. I can see not releasing the source until GPL verification.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...