In short a program which requires FTP access stops being able to access FTP through command prompt interface after about 45 minutes of the router being on. Turning the router off and on does fix the problem for about a half hour. Ive had this problem on numerous WRN210's and the way we fixed it previously was the unrelease Firmware 1.1.17. After ungrading to that release there is no issue. However im unable to find a download link to that firmware at this time.
Re: WRV210 FTP blocks, Looking for Firmware 1.1.17
Thats the verison number for the quick client, but the firmware according to cisco tech is 1.1.16. The gentlemen i talked to said i might be out of luck, and that he would email me if he found anything additional.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...