Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WRV210 Lockup

Purchased three WRV210 to interconnect two small remote offices via IPSEC VPN to

the main office.  All three offices use Windstream T1 routers/IADs (Cisco).

The main office router was installed 21 days ago.

10 days ago, I configured the main office WRV210 for an IPSEC tunnel to

the first remote office.  I configured the router for the first remote office, which was

received, but not yet installed.  6 days ago, the WRV210 at the main office locked up.

It locked up again the following day.  It locked up twice Friday, and multiple times

over last weekend.

I replaced the router at the main office with the one designated for use at remote

office #2.  I downloaded the config.bin from the original router to the new one.

The new router lasted about 5 hours before locking up.

Based upon some other threads here, I disabled the one defined tunnel at the main

office.  Unit is running DHCP service, and has Wireless SSID defined, but not yet

used by any clients.  Unit particulars:

Hardware Version:WRTR-221G_V01
Software Version:2.0.0.11
Current Time:2010/11/22 Mon 15:06:18 (GMT -05:00)
System Up Time:1h:15m:31s
MAC Address:

00:25:9C:A9:FB:D5

Any suggestions?

268
Views
0
Helpful
0
Replies
CreatePlease to create content