Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WRV210 loses port forwarding settings after reboot

Along with wireless problems that have already been documented about this device I am having problems with port forwarding where it will lose all its settings after losing its power.  I then try to go into the management for port forwarding and am not able to put the settings back in as every time I hit 'Save' it just loads the page back up with no settings applied.  Another strange thing is that the protocol comboboxes only have options for UDP or Both. 

I then reapply the latest firmware and am able to enter the settings again.

Any help would be greatly appreciated as I'm at my wits end with this one.

Thanks,

Paul

Everyone's tags (4)
1 REPLY
Bronze

WRV210 loses port forwarding settings after reboot

Dear Paul,

Thank you for reaching the Small Business Support Community.

If you are already running the latest firmware release version 2.0.1.5, all I can suggest you is to contact the Small Business Support Center directly to determine if this is a hardware related problem, notice this product is already End of Life/End of Support and therefore the support is subject to warranty or contract terms and conditions;

https://supportforums.cisco.com/community/netpro/small-business/sbcountrysupport

Please do not hesitate to reach me back if there is any further assistance I may help you with in the meantime.

Kind regards,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

Jeffrey Rodriguez S. .:|:.:|:. Cisco Customer Support Engineer *Please rate the Post so other will know when an answer has been found.
286
Views
0
Helpful
1
Replies