WRV210 Message: Tunnel Adding...Please reflash this page
I've managed to configure my WRV210 router to make VPN tunnel with another WRV210 with no problems. When I try to configure a second tunnel to other WRV210 in other place, everytime I press the "Details" button for that tunnel I get the following message: "Tunnel Adding...Please reflash this page." and nothing happens. The VPN tunnel never gets connected.
I'm sure the settings are the same at both ends and that they are correct. Also I'm using a static IP in one end and a dinamic IP at the other end with DDNS configured and working (I have the same configuration with the first tunnel with absolutly no problems).
What does this message mean and what should I do to make my VPN tunnels to work?
Also, does anybody knows how much time does it take to reconnect a VPN tunnel if my dinamic IP changes? How quick is the DDNS client in the router to realize that the router's IP address has changed and refresh DynDNS with the new IP address?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...