Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WRV210 Port Forwarding not opening ports

Greetings,

I have a Linksys/Cisco WRV210 Wireless-G VPN  Router with RangeBooster.  ISP provides dynamic IP with all ports  open.  I have no equipment to interact with from them; they just provide  me a CAT5 cable out of the wall.  ISP -> WRV210 -> LAN

Router Stats

  Hardware Version: WRTR-221G_V1

  Software Version:  2.0.0.11

  Connection Type:  Automatic Configuration - DHCP

  IP Address: 10.1.222.104

  Subnet Mask: 255.255.255.0

  Default Gateway:  10.1.222.1

Port Forwarding 22152- 22152 192.168.1.152 Enabled

Port Triggering none

DMZ disabled

If I test within the LAN

nmap -p22152 192.168.1.152
Interesting ports on 192.168.1.152:
PORT      STATE SERVICE
22152/tcp open  unknown

If I test from outside the router (xxx and ### are just my masking edits)

nmap -p22152 desktop.dns.xxx
Interesting ports on ##.###.##.###:
PORT      STATE  SERVICE
22152/tcp closed unknown

If I test from inside the LAN directed at the router

nmap -p22152 192.168.1.1
Interesting ports on 192.168.1.1:
PORT      STATE  SERVICE
22152/tcp closed unknown

It would seem  the router is completely ignoring my Port Forwarding instructions.  I  have hard reset the router.  I have upgraded to the lastest firmware.   None of these has made a difference.

My last test was to see if any ports are open on the router

nmap 192.168.1.1
Interesting ports on 192.168.1.1:
Not shown: 997 closed ports
PORT      STATE SERVICE
80/tcp    open  http
443/tcp   open  https
60443/tcp open  unknown

My questikon would be if anyone has a "trick" to activate port forwarding on the route?

Thank you.

Everyone's tags (2)
1363
Views
0
Helpful
0
Replies