I recently bought the WRVS4400N router and have troubble configurating the QoS for the VOD of my ISP.
The original internet router (Motorola) was provided by my ISP and the box for the VOD was directly connected through local network.
Now I configured my new WRVS4400N to by used as the gateway and use the original Motorola router as bridge for the internet access. Everything works fine for the internet but the VOD does not work properly. When I started it, I works for 2 minutes and stops until I change channel. Then it also work for a couple of minutes. I seems to me that it's like a QoS issue, but the problem is happening even with no "normal" internet traffic.
Does somebody have experience or documentation about VOD/QoS/Multicasting with the WRVS4400N?
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...