I am trying to create an IAP for a single computer based on it's MAC address. I want to block certain keywords and websites 24/7. When I setup the IAP as number 1, I add the MAC address of the computer in question. I then Select Allow and choose Everyday and 24 Hours. I type in the forbidden domains and click add after each one. I type in the keywords and click add after each one. After I click on Save, all of my computers on the network lose internet access.
Am I doing something wrong?
I have WRVS4400N VPN Version 2, firmware version 18.104.22.168
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...