I have purchased this router for 2 of my clients (at different times) in the past year. Both have the same problem - they loose connectivity (both wired and wireless) and they also loose all their settings (SSID, etc). I re-configure them and they work from a few days to a month or more, then the same problem. I have upgraded firmware, and both are on a UPS. Both are running in a simple DHCP/router mode from a single ISP and no VPN set-up.
Should I contact support for both units to be replaced?
i've experienced the same problem several times till now and think that it's more likely to happen when someone establishes a vpn router <-> client connection. it happend to me twice, so after 2-3 minutes connected the connection to the router (via wan) is lost. the device wont respond to a ping, vpn connect, web, ... on lan, wan and w-lan and stops routing too.
have you found a resolution or did cisco offer you two new devices?
(i'm afraid that, if i open a case on this bug, that it would be closed with a "works for me", because it takes 20-40 days till this problem occurs)
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...