No , you didn't miss anything, this should be working. I would verify that port 2000 is open by from the outside. You should be able to scan it with Nmap. Also try another port rather than 2000. Next make sure the PC you are sending RDP traffic has a Default gateway of WRVS4400N - If you only have WRVS4400N(Router), and it's giving out DHCP - then this really shouldn't be a problem. Also make sure you are running latest firmware on WRVS4400N...
firewall --> sigle port forward --> Application name --> RDP
---> External port --> 2000
--> Internal port -->3389
protocol --> TCP -----(PC IP-address)-----> Then "enable"
Can you provide the version number of the WRVS4400N that you have? You can find this information on the bottom of the product located on the product id label. You should see no version info if it is a version 1.0. If it is version 1.1 it will be marked as such. If it is a version 2.0 it will be marked as such. This information will help determine which firmware image you should be using with the product.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...