Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WRVS4400N SNMP Questions

When I walk the SNMP tree, I see the ports below but they don't seem to match the hardware.  This devices has 4 Ethernet LAN ports + 1 Ethernet WAN port + 1 Radio

I have eth1, eth2, eth4, WAN, and the radio active and the SNMP walk shows eth0, eth1, eth2, ipsec0, br0 as up and connected.  Have a found a SNMP mismatch or where am I missing the ports?

Thanks in advance for your assistance

iso.3.6.1.2.1.2.2.1.2.1 = STRING: "lo"
iso.3.6.1.2.1.2.2.1.2.2 = STRING: "eth0"
iso.3.6.1.2.1.2.2.1.2.3 = STRING: "eth1"
iso.3.6.1.2.1.2.2.1.2.4 = STRING: "eth2"
iso.3.6.1.2.1.2.2.1.2.5 = STRING: "teql0"
iso.3.6.1.2.1.2.2.1.2.6 = STRING: "sit0"
iso.3.6.1.2.1.2.2.1.2.7 = STRING: "tunl0"
iso.3.6.1.2.1.2.2.1.2.8 = STRING: "gre0"
iso.3.6.1.2.1.2.2.1.2.9 = STRING: "ipsec0"
iso.3.6.1.2.1.2.2.1.2.10 = STRING: "ipsec1"
iso.3.6.1.2.1.2.2.1.2.11 = STRING: "ipsec2"
iso.3.6.1.2.1.2.2.1.2.12 = STRING: "ipsec3"
iso.3.6.1.2.1.2.2.1.2.13 = STRING: "br0"

Everyone's tags (1)
671
Views
0
Helpful
0
Replies