I have recently purchased a WRVS4400N with the main purpose of opening a VPN link to a clients network. I have had no success to this point an the support options for this product are impossible to track down.
The Linksys site bounces me to the Cisco site.. and the Cisco site has little or no information on the product.
These VPN issues seem to be VERY common as I can find a lot of questions on the internet, however, answers are few and far between.
Is there a proper guide on the use of Quick VPN and the setup of routers/gateways on both ends?
Where is the Linksys / Cisco support for this product and it's various software(s.)
Not that it'll help you much; that's also where I end up whenever I've tried to make it work. And yes, there's alot of posts with people having problems and not really any that tells you how to fix it.
Hello, This article will describe how to configure PPTP VPN on the new
RV340/345 routers from the Small Business series. RV340/345
Configuration The first step is to enable the PPTP Server: Go to VPN ->
PPTP Server Change PPTP Server: from Off to On Selec...
Article ID:5748 Use TheGreenBow VPN Client to Connect with RV34x Series
Router Introduction A Virtual Private Network (VPN) connection allows
users to access, send, and receive data to and from a private network by
means of going through a public or share...
Article ID:5728 Configure a Teleworker VPN Client on the RV34x Series
Router Objective The Teleworker VPN Client feature minimizes the
configuration requirements at remote locations by allowing the device to
work as a Cisco VPN hardware client. When the T...