cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3090
Views
0
Helpful
5
Replies

WRVS4400N Telnet

Genome_666
Level 1
Level 1

Hi guys

Is it possible to telnet into the 'WRVS4400N Wireless-N Gigabit Security Router with VPN' router? When I try it says the remote system refused the connection.

1 Accepted Solution

Accepted Solutions

linksysinfo
Level 4
Level 4

There is no Telnet/SSH on the vast majority of WRVSx/RVx routers.  you could check OpenWRT to see if anyone has created a 3rd party firmware for it, but i doubt it very much,

Regards Simon
http://www.linksysinfo.org

Regards Simon

View solution in original post

5 Replies 5

linksysinfo
Level 4
Level 4

There is no Telnet/SSH on the vast majority of WRVSx/RVx routers.  you could check OpenWRT to see if anyone has created a 3rd party firmware for it, but i doubt it very much,

Regards Simon
http://www.linksysinfo.org

Regards Simon

Dean Thompson
Level 1
Level 1

http://wiki.openwrt.org/toh/cisco/wrvs4400n_v2

It looks like something has been made for it, I may try this on my router to see if it fixes my radio problems.

Pity it doesn't support telnet with the provided firmware.

What radio problems are you having? I'm also having problems with it disconnecting on my macs randomly.

Frequent disconnects of all wireless clients, clients unable to reconnect for minutes after.  Normally after streaming, downloading and such, even browsing the net did it.

Cisco replaced my unit with a new one, of which has worked out great.  I still see diconnects for a key renewel but it reconnects within a second or two.

My issues are resolved now

Lol I had the EXACT same issue. Cisco took back all 8 of them. Now going the aironet way. getting the 1041 and a controller. So excited for it to arrive ^_^

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: