WRVS4400N v1 Router with 3 WRT600N (Access Points) locks Internet access
Have the following equipment
1. WRVS4400N (DHCP Services and connected to DSL modem on different subnets, QuickVPN enabled but not working)
2. 3 WRT600N used as Access Points troughout the house connected to the ports on the above router
The problem is that after working for a while the internet access locks out.... although the wireless laptops get an IP address and can see other network equipment they can't access the internet. After a restart on the WRVS4400N everything works again.
If I connect to one of the ports on the DSL everything is always working. So what could be causing the problem? I don't want the client to have to restart the WRVS4400n router every day.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...