Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Additional interface card for PIX 515E?

We have a PIX 515e. This has 2 built in ethernet interfaces. My requirement is to add an additional interface card to this device so that I can add a DMZ to my network.

Below is the sh version output of my PIX:

sh ver

Cisco PIX Security Appliance Software Version 8.0(3)
Device Manager Version 6.0(2)
Compiled on Tue 06-Nov-07 19:50 by builders
System image file is "flash:/pix803.bin"
Config file at boot was "startup-config"

Encryption hardware device : VAC+ (Crypto5823 revision 0x1)
0: Ext: Ethernet0           : address is 0013.7fdd.2671, irq 10
1: Ext: Ethernet1           : address is 0013.7fdd.2672, irq 11

Licensed features for this platform:
Maximum Physical Interfaces  : 6
Maximum VLANs                : 25
Inside Hosts                 : Unlimited
Failover                     : Active/Standby
VPN-DES                      : Enabled
VPN-3DES-AES                 : Enabled
Cut-through Proxy            : Enabled
Guards                       : Enabled
URL Filtering                : Enabled
Security Contexts            : 2
GTP/GPRS                     : Disabled
VPN Peers                    : Unlimited

This platform has a Failover Only-Active/Standby (FO) license.

It shows "Maximum Physical Interfaces  : 6". So, I guess I could extend the number of interfaces.  Can some one please confirm this?

Also, it will be a great help if you could specify the part number of the interface card I should purchase (single port or multi port).

Thanks in advance for any help,

Ribin

4 REPLIES
New Member

Re: Additional interface card for PIX 515E?

“Thank you for your question.  This community is for Cisco Small Business products and your question is in reference to a Cisco Elite/Classic product.  Please post your question in the Cisco NetPro forums located here:

http://forum.cisco.com/eforum/servlet/NetProf;jsessionid=E0EEC3D9CB4E5165ED16933737822748.SJ3A?page=Security_discussion

This forum has subject matter experts on Cisco Elite/Classic products that may be able to answer your question.”

THANKS

New Member

Re: Additional interface card for PIX 515E?

That link forwards me to https://supportforums.cisco.com/index.jspa.

- Ribin

New Member

Re: Additional interface card for PIX 515E?

Yes--That is the correct link. At that link under Security choose Firewalling  and you will be in the correct Community for the

PIX postings and discussion.

THANKS

New Member

Re: Additional interface card for PIX 515E?

Thanks.

250
Views
0
Helpful
4
Replies